Finishing the Mci's

Well not a lot to talk about today. We finished u the mci's I was talking about. Five of them in total. Quick tip about the mci engine from EZ Go, or the pre-mci for that matter, make sure that when you tighten your valves that they are actually "tight". I've seen this happen countless times with engines of all makes and models. The thing is, that with the EZ Go models, most people set the timing on the engine by looking at the large timing gear. When the "dot" is at the top end of the gear we set the back two valves. And when the dot is at the bottom of the gear we set the front two valves. This however is the incorrect way. It does work, but it has a tendency to be a headache. If you are an individual who is in a hurry, then go ahead, you can always adjust your valves later, should you feel the need to. But if you are a business owner you should set the valves the correct way the first time. By the correct way I mean that each valve should be set at .004in independently. When the lobe of the camshaft is at the 7 o'clock position and the rocker arm is to the right of your line of sight. I'll cover small topics that can be archived daily, but for anything that you think should be covered, please let me know at spearsgolfcarts@gmail.com and I will address it in the very next blog I post.